Qi avt2 RC3
Wolfgang Spraul
wolfgang at qi-hardware.com
Thu Dec 3 21:35:08 EST 2009
[re-post becauser Werner is not subscribed to the list...]
On Thu, Dec 03, 2009 at 11:05:07AM -0500, Carlos Camargo wrote:
> >
> > Hmm, so this is still messy :-( I haven't followed the KiCad lists
> > for a while and I was hoping that these issues had been solved now.
> > Well, at least there's a work-around.
> >
> >
> Werner, Do you know the internals of kicad project? Can you help with this
> copper pour problem? As you know this zone is very important, and save a lot
> of time.
>
>
>
> > >> We maka all footprints in kicad, we found fped later :(
> >
> > Ah, pity. Might have saved you some rather boring work ... and it
> > would have gotten me some more testers ;-)
>
>
> We will use fped and we will report our experiences.
>
>
> Best Regards
>
>
> Carlos
>
>
>
>
> > - Werner
> >
> > _______________________________________________
> > Qi Developer Mailing List
> > Mail to list (members only): developer at lists.qi-hardware.com
> > Subscribe or Unsubscribe:
> > http://lists.qi-hardware.com/cgi-bin/mailman/listinfo/developer
> >
>
>
>
> --
> Carlos Iván Camargo Bareño
> Profesor Asistente
> Departamento de Ingeniería Eléctrica y Electrónica
> Universidad Nacional de Colombia
> cicamargoba at unal.edu.co
> _______________________________________________
> Qi Developer Mailing List
> Mail to list (members only): developer at lists.qi-hardware.com
> Subscribe or Unsubscribe: http://lists.qi-hardware.com/cgi-bin/mailman/listinfo/developer
More information about the discussion
mailing list