What does this Error stand for?

XiangFu Liu xiangfu at qi-hardware.com
Wed Sep 30 18:33:46 EDT 2009


Hi  Adam

write down all command you have run.
try "sudo usbboot -c "boot;nquery"

On Tue, Sep 29, 2009 at 8:44 PM, Adam Wang <adam at qi-hardware.com> wrote:

> Hi,
>
> Is there anyone knows that this Error stand for?
>
> Can describe in more details like that the software it wants to do what
> tasks in hardware side and get this error?
> Thanks,
> Adam
>
> ==========================================================================
>
> Now checking whether all configure args valid: YES
> Current device information:
> CPU type is Ingenic XBurst Jz4740
> Crystal work at 12MHz, the CCLK up to 252MHz and PMH_CLK up to 84MHz
> SDRAM Total size is 32 MB, work in 4 bank and 16 bit mode
> Nand page per block 128, Nand page size 4096, ECC offset in OOB 12, bad
> block offset in OOB 0, bad block page 127, use 1 plane mode
> Execute command: nprog 0 openwrt-xburst-u-boot.bin 0 0 -n
> Programing No.0 device, flen 469224, start page 0...
> CPU data: Boot4740
> Erasing No.0 device No.0 flash (start_blk 0 blk_num 1)......
> Finish! Return: 80 00 00 00 00 00 00 00 (position 1)
> Force erase, no bad block infomation!
> Size to send 469224, transfer_size 524288
> Image type : without oob
> It will cause 1 times buffer transfer.
> Writing NAND page 0 len 471040...
> CPU data: Boot4740
> Finish! (len 471040 start_page 0 page_num 115)
> Error - can't set the address on Ingenic device: -110
> Error - can't set data length on Ingenic device: -110
> Error - can't set Ingenic device nand ops: -110
> Checking 471040 bytes... no check! End at Page: -193254056
> Skip a old bad block !usbboot - Ingenic XBurst USB Boot Utility
>
>
> _______________________________________________
> Qi Developer Mailing List
> Mail to list (members only): developer at lists.qi-hardware.com
> Subscribe or Unsubscribe:
> http://lists.qi-hardware.com/cgi-bin/mailman/listinfo/developer
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.en.qi-hardware.com/pipermail/discussion/attachments/20091001/c041f370/attachment.htm>


More information about the discussion mailing list


interactive