[SAKC] draft bom
cicamargoba at gmail.com
Wed Feb 3 06:51:51 EST 2010
On Wed, Feb 3, 2010 at 6:03 AM, Adam Wang <adam at sharism.cc> wrote:
> Hi Carlos,
> How pcb's thickness of SAKC board you want? 1.6mm ?
> This may influence those p/n of headers you chose.
1.6mm Is good for me no problem.
I'll fill the red rows on the .ods file, and I'll upload to the git
> On Wed, Feb 3, 2010 at 6:56 PM, Adam Wang <adam at sharism.cc> wrote:
> > Hi Carlos,
> > According to your bom on git, I am planinng to prepare the
> > necessary parts. So I compared this bom with our inventory parts
> > and make .ods bom.
> > Need your help to fill in. Then please delete the txt file on git or
> > point its content into the link of this new file.
> > The red rows are needed a exact p/n. The headers you can just point me
> > a picture or digi-key links.
> > The blue rows are recommended that using our inventory parts already.
> > Some of our parts are kept available almost in 1k qty'. This inventory
> > file is not quite good now, but still a good info. I can keep maintain
> > and put each Warehouse Lot (WL) number to link exact datasheet later.
> > Those are for trial & prototype run.
> > Thanks,
> > Adam
> > 
> > 
> >  http://downloads.qi-hardware.com/hardware/sakc/bom/sakc_RC1_bom.ods
> Qi Developer Mailing List
> Mail to list (members only): developer at lists.qi-hardware.com
> Subscribe or Unsubscribe:
Carlos Iván Camargo Bareño
Departamento de Ingeniería Eléctrica y Electrónica
Universidad Nacional de Colombia
cicamargoba at unal.edu.co
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the discussion