Serial debugging

Xiangfu Liu xiangfu at sharism.cc
Wed Feb 17 10:45:43 EST 2010


Hi 
yes. need press [POWER] + [S] see this http://en.qi-hardware.com/wiki/Boot_mode
and I just check the nanonote kernel config in openwrt. it's already enable the 
serial console driver.

David Reyes Samblas Martinez wrote:
> Someone correctme if I'm wrong but I think you had to press power+s on
> power on the device to activate serial console
> 

> El día 17 de febrero de 2010 14:20, Richard Chávez
> <rjchavezb at gmail.com> escribió:
>> Hi everybody,
>>
>> I want to make debugging of the nanonote suspend/resume activities but
>> I need some guidance about it. I know how to stablish a serial
>> connection with my PC using minicom and connecting an RS232 converter
>> to the TX, RX, GND pins on Ben but, what is next after that? Does Ben
>> send the debugging info via serial interface by default?
>>
>> Thanks for your help.
>>
>>
>>
>> --
>> Ing. Richard Chávez Borja
>> Microensamble
>> www.microensamble.com
>> Teléfono: 3470801 - ext 106
>> Dirección Skype: rjchavezb
>>
>> _______________________________________________
>> Qi Developer Mailing List
>> Mail to list (members only): developer at lists.qi-hardware.com
>> Subscribe or Unsubscribe: http://lists.qi-hardware.com/cgi-bin/mailman/listinfo/developer
>>
> 
> 
> 





More information about the discussion mailing list


interactive