the ks7010 wifi card not work in my NanoNote

Xiangfu Liu xiangfu at sharism.cc
Tue Jan 19 01:08:28 EST 2010


Hi

when the Nanonote boot the led in SDW-823 just flash once.

compile with the -DKS_WLAN_DEBUG=6
the last message of dmesg is "[   23.610000] ks7010_sdio : Jan 19 2010 13:46:12"

then I unplug and plug the card again. there are two message:
[  114.020000] mmc0: host doesn't support card's voltages
[  114.020000] mmc0: error -22 whilst initialising SDIO card

I try to static link the module to kernel. give error message:
[   10.300000] mmc0: bad CISTPL_FUNCE size 28 type 1
[   10.310000] mmc0: error -22 whilst initialising SDIO card



Javi Roman wrote:
> On Mon, Jan 18, 2010 at 6:06 PM, Xiangfu Liu <xiangfu at sharism.cc> wrote:
>> Hi Lars, Javi
>>
>> after Nanonote boot.
>> I run "insmod ks7010" to install the module.
>> then at the end of dmesg there is "[  144.170000] ks7010_sdio : Jan 19 2010
>> 00:27:53"
>>
>> but when I run "ifconfig -a" "iwconfig" there is no eth0.
>> only lo and usb0.
>>
>> what wrong with my step?
>>
>> thanks
>>
> 
> I'm going to test it, meanwhile can you compile the module with
> -DKS_WLAN_DEBUG=6 and post the log?
> 
> Regards.
> 





More information about the discussion mailing list


interactive