SAKC BOARD

Carlos Camargo cicamargoba at gmail.com
Sun Jan 24 20:54:40 EST 2010


I've uploaded the new block diagram [1]


http://wiki.qi-hardware.com/wiki/Block_Diagram



Carlos


On Sun, Jan 24, 2010 at 5:48 PM, Carlos Camargo <cicamargoba at gmail.com>wrote:

> I'm thinking in the SAKC design, my design is similar to ztex board,
> so I think that make a similar board has no sense. Right now we can
> buy ztex board.
>
> Right now I'm finishing a development board (using ORCAD) based on
> ingenic 4725 chip, this board use one spartan 3 FPGA, up to 64 MB
> SDRAM, 2GB NAND, micro SD LCD connector (the same LCD used in
> NanoNote) 8 channels Analog to Digital converter, 20 digital IOs (FPGA
> pins), usb device connector.
>
> I think that this board will be more convenient for us, we can use the
> same development enviroment and we can re-use the existing software.
>
> This board is almost finished, so. we can build a prototype this week.
> (Of course the next task will be convert the design files to kicad )
>
> I want to hear your comments
>
> Best regards
>
> Carlos
>
> --
> Carlos Iván Camargo Bareno
> Profesor Asistente
> Departamento de Ingeniería Eléctrica y Electrónica
> Universidad Nacional de Colombia
> cicamargoba at unal.edu.co
>



-- 
Carlos Iván Camargo Bareño
Profesor Asistente
Departamento de Ingeniería Eléctrica y Electrónica
Universidad Nacional de Colombia
cicamargoba at unal.edu.co
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.en.qi-hardware.com/pipermail/discussion/attachments/20100124/e9e20639/attachment.htm>


More information about the discussion mailing list


interactive