Adam Wang adam at sharism.cc
Tue Jan 26 21:06:04 EST 2010

Hi Carlos,

I just found that [1] a) the outside ring of key btn have short with
GND, it can not be detected during DRC stage.
b) Can the mask & solder be same as large as outside circle ring? The
solder layer is a small square on the outside ring, it cant be like
rc1 version. So I think the contact area won't be good during metal
domn push.

[1] http://en.qi-hardware.com/wiki/Layout_notes_avt2_RC2_20100126

More information about the discussion mailing list