BEN's LCD works on SAKC

Xiangfu Liu xiangfu at sharism.cc
Fri Mar 12 09:30:56 EST 2010


Hi Carlos
COOL 

Carlos Camargo wrote:
> Hi
> 
> As you can see in [1], BEN's LCD works on SAKC.
> I make a mistake on LCD connector, I swap the pinout :(, I Sold the tape 
> directly to SAKC PCB, and works fine...
> 
> Right now, I'm trying to configuring the FPGA using GPIOs and xc3sprog
> 
> 
> Carlos
> 
> [1] http://en.qi-hardware.com/wiki/Swiss_Army_Knife_Card
> 
> -- 
> Carlos Iván Camargo Bareño
> Profesor Asistente
> Departamento de Ingeniería Eléctrica y Electrónica
> Universidad Nacional de Colombia
> cicamargoba at unal.edu.co <mailto:cicamargoba at unal.edu.co>
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> Qi Developer Mailing List
> Mail to list (members only): developer at lists.qi-hardware.com
> Subscribe or Unsubscribe: http://en.qi-hardware.com/mailman/listinfo/developer





More information about the discussion mailing list


interactive