How to fit Mico32 on SAKC?

Carlos Camargo cicamargoba at gmail.com
Wed May 26 18:33:14 EDT 2010


Thanks a lot,

I'll try


Carlos


On Wed, May 26, 2010 at 11:14 AM, Sébastien Bourdeauducq <
sebastien.bourdeauducq at lekernel.net> wrote:

> On Wednesday 26 May 2010 17:40:55 Carlos Camargo wrote:
> > One question: SAKC don't save RAM or ROM memory, just the internal, there
> >  is a sample program like hello world running from internal ram
>
> The easiest option is probably to remap the block RAM (bram) to address 0
> (by
> editing board/xxx/rtl/system.v) and recompile the BIOS to put all the data
> into it (you need to change the addresses in software/bios/linker.ld).
> Finally, just initialize the block RAM with the BIOS binary (see how
> soc-lm32
> does) and you should be all set.
>
> Sébastien
>
> _______________________________________________
> Qi Developer Mailing List
> Mail to list (members only): developer at lists.qi-hardware.com
> Subscribe or Unsubscribe:
> http://en.qi-hardware.com/mailman/listinfo/developer
>



-- 
Carlos Iván Camargo Bareño
Profesor Asistente
Departamento de Ingeniería Eléctrica y Electrónica
Universidad Nacional de Colombia
cicamargoba at unal.edu.co
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.en.qi-hardware.com/pipermail/discussion/attachments/20100526/ceae4cfb/attachment.htm>


More information about the discussion mailing list


interactive