anelok: Y-Box V2 first pictures

Bas Wijnen wijnen at
Fri Jan 31 00:48:55 EST 2014

Looks good!

On Thu, Jan 30, 2014 at 08:14:35PM -0300, Werner Almesberger wrote:
> After tinning and adding the most important vias:

Interesting.  I though for smd boards, it was required to use solder
paste and a mask (to prevent the paste from going all over the board).
How does this method work?  You just add the components and heat it up
to make them stick?  Or do you need extra solder paste or something like
it?  How do you heat it up, with hot air, an iron, or an oven?


More information about the discussion mailing list