Anelok: revised case (WIP)

Ron K. Jeffries rjeffries at gmail.com
Mon Jul 13 14:52:07 UTC 2015


Your (clever) case design + electronic design may be useful for more than
just the anelok password safe.
On Jul 13, 2015 12:30 AM, "Werner Almesberger" <werner at almesberger.net>
wrote:

> The results of a weekend of case-tweaking:
>
>
> http://downloads.qi-hardware.com/people/werner/anelok/tmp/case-interim/empty-20150713.png
>
> Main changes:
> - the screws are M2 with a nominal thread length of 7 mm,
> - the screws move perpendicular to the bottom face (i.e., "vertically"),
> - the lanyard hole is vertical, too, and less twisty,
> - the USB connector (highlighted in green) is much closer to the
>   battery.
>
> Known issues:
> - still no cut-outs for USB and the switch,
> - the lanyard hole does not end well at the bottom - I should
>   make the whole corner part of the top shell
>
> The STLs:
>
> http://downloads.qi-hardware.com/people/werner/anelok/tmp/case-interim/top-20150713.stl
>
> http://downloads.qi-hardware.com/people/werner/anelok/tmp/case-interim/bottom-20150713.stl
>
> The source:
> https://gitlab.com/anelok/anelok/blob/master/me3/case.py
>
> - Werner
>
> _______________________________________________
> Qi Hardware Discussion List
> Mail to list (members only): discussion at lists.en.qi-hardware.com
> Subscribe or Unsubscribe:
> http://lists.en.qi-hardware.com/mailman/listinfo/discussion
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.en.qi-hardware.com/pipermail/discussion/attachments/20150713/9b4f9ed9/attachment.html>


More information about the discussion mailing list


interactive