Hi Adam



On Wed, Feb 3, 2010 at 6:03 AM, Adam Wang <adam@sharism.cc> wrote:
Hi Carlos,

How pcb's thickness of SAKC board you want? 1.6mm ?
This may influence those p/n of headers you chose.


1.6mm Is good for me no problem.

I'll fill the red rows on the .ods file, and I'll upload to the git repository

Carlos



Carlos

 
Adam

On Wed, Feb 3, 2010 at 6:56 PM, Adam Wang <adam@sharism.cc> wrote:
> Hi Carlos,
>
> According to your bom on git[1], I am planinng to prepare the
> necessary parts. So I compared this bom with our inventory[2] parts
> and make .ods bom[3].
> Need your help to fill in. Then please delete the txt file on git or
> point its content into the link of this new file.
>
> The red rows are needed a exact p/n. The headers you can just point me
> a picture or digi-key links.
> The blue rows are recommended that using our inventory parts already.
> Some of our parts are kept available almost in 1k qty'. This inventory
> file is not quite good now, but still a good info. I can keep maintain
> and put each Warehouse Lot (WL) number to link exact datasheet later.
> Those are for trial & prototype run.
> Thanks,
> Adam
>
> [1] http://projects.qi-hardware.com/index.php/p/nn-usb-fpga/source/tree/master/design_files/COMPS.TXT
> [2] http://downloads.qi-hardware.com/hardware/qi_avt2/inventory/inventory.ods
> [3] http://downloads.qi-hardware.com/hardware/sakc/bom/sakc_RC1_bom.ods
>

_______________________________________________
Qi Developer Mailing List
Mail to list (members only): developer@lists.qi-hardware.com
Subscribe or Unsubscribe: http://lists.qi-hardware.com/cgi-bin/mailman/listinfo/developer



--
Carlos Iván Camargo Bareño
Profesor Asistente
Departamento de Ingeniería Eléctrica y Electrónica
Universidad Nacional de Colombia
cicamargoba@unal.edu.co