Hi


On Mon, May 24, 2010 at 9:02 PM, cristian paul peñaranda rojas <paul@kristianpaul.org> wrote:
In the process of getting freedom for the nanonote case,
i srated this wiki page [1] to document the process to get
some 3D models from Ben's nanote case

The design file is available here [1]


http://downloads.qi-hardware.com/hardware/design/casing/

Carlos


 

Comment and discussion is wellcome,
Also ideas about why you like to change on the nanonote case (why not ;))

[1] http://en.qi-hardware.com/wiki/3D_Scanning

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.10 (GNU/Linux)

iEYEARECAAYFAkv7L5sACgkQOAZrK37R8yL5owCff1ZRYF6LuvOciagu3Q0WtcBD
1cAAn3zcezfYPj251RgJBZY7siIWY1r3
=XqI8
-----END PGP SIGNATURE-----

_______________________________________________
Qi Developer Mailing List
Mail to list (members only): developer@lists.qi-hardware.com
Subscribe or Unsubscribe: http://en.qi-hardware.com/mailman/listinfo/developer



--
Carlos Iván Camargo Bareño
Profesor Asistente
Departamento de Ingeniería Eléctrica y Electrónica
Universidad Nacional de Colombia
cicamargoba@unal.edu.co