Thanks a lot, 

I'll try 


Carlos


On Wed, May 26, 2010 at 11:14 AM, Sébastien Bourdeauducq <sebastien.bourdeauducq@lekernel.net> wrote:
On Wednesday 26 May 2010 17:40:55 Carlos Camargo wrote:
> One question: SAKC don't save RAM or ROM memory, just the internal, there
>  is a sample program like hello world running from internal ram

The easiest option is probably to remap the block RAM (bram) to address 0 (by
editing board/xxx/rtl/system.v) and recompile the BIOS to put all the data
into it (you need to change the addresses in software/bios/linker.ld).
Finally, just initialize the block RAM with the BIOS binary (see how soc-lm32
does) and you should be all set.

Sébastien

_______________________________________________
Qi Developer Mailing List
Mail to list (members only): developer@lists.qi-hardware.com
Subscribe or Unsubscribe: http://en.qi-hardware.com/mailman/listinfo/developer



--
Carlos Iván Camargo Bareño
Profesor Asistente
Departamento de Ingeniería Eléctrica y Electrónica
Universidad Nacional de Colombia
cicamargoba@unal.edu.co